T4A4H-001_highres_outlinedThis mechanical friction torque limiter was created in response to a customer’s request for a slip clutch with a 3180 pound inch setting and a 44L100 pilot mounted pulley. The first challenge of this application was that the outside diameter of the torque limiter could not exceed the diameter of the pulley. Mach III designed this unit with eight friction surfaces to deliver the required torque within the diameter restriction. 

The second challenge was that the unit had to fit on a 1.25 Inch shaft.  The design could accommodate a 1.25 inch bore, but there was no room for a keyway.  Mach III extended the drive hub and fitted it with a locking collar to connect the torque limiter to the shaft.

View The Spec Sheet